Company Profile
Electrical systems throughout the world are experiencing problems with aging insulation. When an insulation system fails, the results are usually catastrophic. Failure causes substantial financial loses due to lost production and damage to expensive equipment. These losses can amount to thousands of dollars per hour. With the ability to predict when a possible insulation failure will occur, clients will be able to reduce their lost profit opportunities. Industry now and in the future can not tolerate unplanned outages.
Untitled Document
EDI will be attending the following
Conferences and Trade Shows
January 28 – 30, 2008
TechCon 2008 TJ/H2B Chateau Elan Winery
and Resort
Braselton , Georgia
   
February 11-12, 2008
ABB School of Maintenance Transformer Monitoring Technologies Johannesburg South Africa
   
March 2008
Doble Users Conference
Boston MA
   
April 21, 22, 23 2008
IEEE Transmission and Distribution
Chicago, IL
   
Our Product and Services will reduce our clients operating cost by mitigating the risks of these unplanned outages.
 
EDI has a full range of products and services to measure and analyze:
 
Partial Discharge Motors.
Partial Discharge Generators.
Partial Discharge Switchgear.
Partial Discharge Bus Duct.
Partial Discharge Cables.
Partial Discharge Transformers.
On-Line Winding Distortion on Transformers.

On-line Power Factor and Capacitance On High Voltage Bushings, Currrent Transformers and CCVTs.
  New Product Highlight
The DTM (Diagnostic Transformer Monitor) is a microprocessor-based device that continuously monitors bushing insulation based on the sum of currents method and partial discharges that may be produced due to bushing and transformer insulation defects. With additional load current signals it allows the detection of critical winding deformation resulting from short circuits.

Home    |    Site Map    |    Contact Us
© 2007 All rights reserved.